Does not have the metal cations can be igneous rocks from the solution, if hydroxyl ions on the cathode recovery for the adverse reaction of the main influence of hydrogen, plating equipment manufacturer is metal cations can't dissolve in the cathode. According to the test, probability, the igneous rock in the metal ions from the solution can be obtained from the periodic table some regularity.

Divided into soluble anode, and not soluble anode, most of the anode coating with the corresponding soluble anode, such as: hot dipped galvanized zinc anode, gold-plated silver anode, tin - lead alloy using tin - lead alloy anode. But a handful of plating process due to the anodic dissolution difficulty, using soluble anode, such as acid alkaline electroplating is using a platinum or titanium anode. Plating solution of main salt cations by adding configured standard gold solution to fill. Stainless steel anode using pure lead, lead and tin alloy, such as lead, antimony alloy not soluble anode.
Electroplating equipment manufacturer

Refers to the general term for all the electroplating equipment in the process of industrial products electroplating, the electroplating process of the equipment manufacturer must be completed in accordance with the sequence, the automatic production line of electroplating process, also known as the production line of electroplating process. Kejada electroplating production line includes automatic electroplating production line and manual automatic electroplating production line. Electroplating production line according to the electroplating process can be divided into hanging plating production line, rolling plating production line, continuous plating, brush plating production line and so on.

Electroplating process line for precious metal plating process, such as nickel plating, gilt, plating, etc., including a full set of process of electroplating process tank, stainless steel sink, and production lines near the electroplating equipment (including corrosion resistant plating rectifier power supply, high precision filter, tunnel drying oven, petrol and diesel stove, industrial pure water machine, refrigerator), and organic exhaust waste gas treatment system. Manual electroplating production line is flexible in design and layout, occupies a small area, can have 2 to 3 production processes at the same time, and can meet the electroplating process of various parts.

The main difference between upgrading and upgrading of electroplating process line of electroplating equipment manufacturer and degree electroplating process line lies in the different mode of transportation of circuit board, while the maintenance and maintenance methods of the tank are not large in essence.

To each hand washing tank to terminate a cleaning of the pickling tank, terminate a cleaning and replace the tank fluid; The self-spraying installation in the tank shall be terminated once to check whether the blockage is shown. The plating process line shall be updated and upgraded to stop dredging in time if the blockage is shown. The conductive rubber support and anode on the rolling bath and tin bath and the contact position of Star Wars empire can be wiped with towel and polished with sandpaper to terminate polishing. Terminate the first inspection of the titanium basket and tin bar basket of the rolling plating bath and tin plating bath, replace the rotten titanium basket bag and tin bar basket, and add copper ball and tin bar, and terminate the titanium electrode of the copper plating bath and tin plating bath after adding the copper ball and tin bar for 7d.